Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are having issues with saving configurations on a stack of three 3750X switches. When issuing a wr mem command, the following messages appear: nv_done: unable to open "flash:/config.text.new"nv_done: unable to open "flash:/private-config.text.new"...
Is it possible to have multiple destination interfaces monitoring the same source interface? Our Security Officer wanted to compare our current Fidelis product with an IronNet product by having both monitoring the same source interface at the same ti...
Hi, It was reported by an onsite team member (in a different facility) that a port "went bad" on one of the modules (WS-X4748-RJ45-E) installed in their WS-C4507R+E. I do not have much information as to what means "went bad" since I have not been ab...
I have been tasked to manually move all devices using TACACS+ authentication on an ACS 5.3.0.40 to ISE 2.6 (Patch 7). I have moved a majority of our switches and routers to ISE successfully and I am currently attempting to move two Nexus 5548 switch...
Thanks!Would you recommend going to 15.2.4E10 MD (c3750e-universalk9-mz.152-4.E10.bin), which is the Suggested Release version from Cisco? Can I go straight to this version from the current version? Anything to be aware of when upgrading to latest ...
Thank you.The problem switch is the master switch, so should I change the priorities on the switches to make one of the others as the "new" master switch before doing what you recommend?When I do a dir flash2: and dir flash3:, the VLAN.dat file is li...
Thank you for your advice. I ran the debug as you suggested when it was pointing to the new ISE host server and took capture of the output. I then did the same when it was pointing to the old ACS servers. I compared the two and there are some diffe...
Thank you for your advice. The following command is what we have inputted for the ACS servers: tacacs-server host <ip of ACS host 1> key 7 "shared secret"tacacs-server host <ip of ACS host 2> key 7 "shared secret"aaa group server tacacs+ ACS-SERVERS...
