Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have two pictures above with topology and addressing and vlan table I have done the ip addressing according to the picture but i am confused with S1 vlan 4 and S2 vlan 4 with vlan 4 in the vlan table why the ip address so different and i hav...
Hi all,I need some direction into right pathThey have given a topology and an example but i am confused with the ip address that how the ip address in the example came and what ip address and subnet mask do i use for this worksheet ahead like this on...
Hi all, I have been given loopback ip addresses 60.50.0.1/16 ,60.100.0.1/16, 60.150.0.1/16, 60.200.0.1/16 and i need to convert them into network address using manual summarization but i have hardly no clue how to do it. Thank you in advance for help...
My main objective is to ping from PCA to PCB , I can ping to both routers R1,R2 from both PCs but cant ping PCA to PCB vice versa. I am using link local address as a ping ip address which i am getting request timed out do you guys have any idea wha...
I have two routers in packet tracer R1 and R2 having g0/1 ip address of 18.200.250.1 and 18.201.250.1 with both subnet mask of 255.255.255.0Both routers have serial DCE cable connectedR1 with s0/0/1 with ip address of 192.168.2.1 255.255.255.252 and ...
Hi @balaji.bandi and @Georg Pauwen,I was given this to make in Packet tracer but before i design or arrange in Packet Tracer i says to connvert the following into network address so I have no clue for that as well but thank you for the commands.
Hi@Martin L,As you suggested i have uploaded PT file and let me know which address i should use for pinging I simply need help in pinging from PCA to PCB only.Thank you
