Hello,How to turn a Cisco sg220-50-port gigabit smart switch into "unmanaged switch" what should i disable to make the switch work like unmanaged one ?Thank you .
i reset switch to default settings, but as i told you when i check vlan management > interface settings, i see all the ports set to trunk by default if not to trunk then to witch one should i select : Access Or General Or Dot1q-Tunnel ?please check t...
i reset switch to default settings, but as i told you when i check vlan management > interface settings, i see all the ports set to trunk by default if not to trunk then to witch one should i select : Access Or General Or Dot1q-Tunnel ?please check t...