Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All, I have a 1941 ISR that will be replacing an 1841 ISR, due to the high CPU utilization being caused by virtual packet reassembly . The biggest problem I'm running into is that IOS 15 doesn't seem to support Pseudowire Xconnect. Has this comman...
I have an interesting PIX issue. A client is trying to route outside traffic to a gateway in a different subnet. I have never seen this configuration before. According to the ISP, I need to run the following config.:ip address outside 206.138.x.x ...
I have an issue with VPN connections being dropped when I have CEF enable, while using GLBP. I'm assuming that as connections are load balanced between the gateways by the active GLBP router, and that the client GLBP router doesn't see the right CEF...
We have currently been experiencing dropped calls we a user answers with the phone's Handset. Headset and speaker phone answer fine. I have tried upgrading the phone load on one of the problem phones with 6.0.5, but this did not fix the issue. Do ...
The issue seems to extend around a clients home office setup. Appearently, there is an ISP whos' directly connected router is in one subnet (private addressing) and the issued client subnet is a Public address. So in this instance the PIX is static...
I'm setting up my lab to test. The issue is with a PIX 501 with Ver 6.3 going into a ISP router. The ISP is running some weird Radio Frequency network connections.
I want to enable it on the same routers that are functioning as the GLBP. I'm running BGP-4 on the routers Serial interfaces (facing the outside) and running GLBP on the ethernet interfaces (facing inside). Current I have CEF disabled, and everythi...
