Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I use oid 1.3.6.1.4.1.9.10.118.1.6.1.1.2 to capture Isis neighbor status. 3 is up and 1 is down. When there is a problem with the link, for example, the interface is closed, the Isis neighbor disappears, and there is no real down. Why?R4#show isis n...
use oid (1.3.6.1.4.1.9.10.65.1.2.2.1.4) to get the status, and the result is:.1.3.6.1.4.1.9.10.65.1.2.2.1.5.x.x.x.x.0.0.2886729866 = INTEGER: 1.1.3.6.1.4.1.9.10.65.1.2.2.1.5.x.x.x.x0.0.2886729870 = INTEGER: 1.1.3.6.1.4.1.9.10.65.1.2.2.1.5.x.x.x.x.0.0...
I encountered a problem when using ZABBIX to monitor IPv6 traffic. The details are as follows:1. IPv4 address and IPv6 address are configured on the interface.2. Use ZABBIX monitoring equipment3. IPv4 use oid: 1.3.6.1.2.1.31.1.1.1.6 And 1.3.6.1.2.1.3...
ha-ha, I misunderstood you. I thought you asked me to choose the candidate path according to the delay.I have just tested, added some configurations, and then can switch candidate paths normally.Thank you very much for your help!!configuration：policy...
Hi Harold， >Starting with 17.4, you can configure performance monitoring on the SR policy to test the end to end connectivity and switchover if there is a failure.I have tested the use of the end to end delay to switch candidate paths. After perf...
Hi Harold， I read the TI-LFA materials this afternoon, and I think my question may have nothing to do with TI-LFA.So,when the router fails (I shut down all interfaces in 4.4.4.4), what does the time required for candidate path switching depend o...
Hi Harold, Yes, I have seen the same description in the book0--“Only the first hop is validated if the the SID list is expressed as MPLS labels”I retested and found that the candidate paths would switch.In the previous test, I waited for a few minute...
