Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to configuration the FC feature on my Nexus 5672UP, everything seem okay but after zoneset activated, nothing happend, server and SAN controller did not see each other.My step:- Enable FCoE feature- Change unified port range to type FC- R...
Hi, i am new to cisco Nexus devices, I am trying to configure default-route:I want to my server (192.168.10.5, vlan 500) can access to default gateway (192.168.1.1) at pfsense.My switch is Cisco N3K-3064PQe1/1 connected to pfsense as routed porte1/5 ...
Hello everyone, I am a newbie at SAN and SAN Networking, I have a Cisco 9148s and IBM Storwize V7000G2+, I try to config cisco 9148S to connect from my HBA Initiator to Target, but after config, nothing happened, my IBM Storage appear port still "Off...
Here is my configuration:switch(config)# show feature | grep fcoe
fcoe 1 enabled
fcoe-npv 1 disabledswitch(config)# sh int brief
------------------------------------------------------------------------...
