Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Sometimes the device isn't being assigned to the right vlan. We wil change vlan and change it back to the right one or sometimes even have to disable the port for about a minute and re-enable it to get the proper vlan configuration on the device.
connect any port to an active connection that allows you to reach the internetonce the switch "checks in" it will give you a green light next to it in the dashboard.then on the left hand column you can configure the IP of the switch in question.
On the other hand, for us it was a problem. our mx450's were showing 100% utilization and we were killing it. It even caused it to reboot until we offloaded dns traffic. I wouldn't say they're 100% accurate but I wouldn't say they should be ignor...
just out of curiosity you might want to call in and check the number of flows going to the device we were having a similar issue and turned out we were flooding the 450 with DNS traffic. We offloaded the traffic and our numbers are looking MUCH bett...
Same issue here. We patched to 18.211.3 and with the high utilization still happening support suggested turning off Multicore access at one location to test. We did that and yesterday we lost auto-vpn between two of our locations.Had to factory res...
