Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Howdy folks!! I'm an old fart here on the Meraki forums. You may know me as @Mr_IT_Guy. At a new company, but had to get a new Cisco account, so here I am! Looking forward to being active again on the forums soon.
@CarolineS1, @daviscot, @anyone at Meraki,Can you give some insight as to how Meraki support escalation works? I currently have a ticket that I was trying to get support help on this morning and was unsatisfied with how the tech (not the one original...
Noticed there is a small typo in a database article:In the table of contents, step 2 has both 2 and 3 listed making the remainder of the list be off by one number. Didn't know who to contact at Meraki about it, so I thought I'd post here since @Carol...
On almost all home routers, you can set up your network to allow only specified MAC addresses to connect. With Meraki, the device has to been seen first before you can deny it. Engineers I've talked to have confirmed this and we've put in several tic...
@Philip D'Ath , not sure how it's a wide use case or require changing anything in the GUI in terms of loss and latency. You already get that information in the MX. Should be just as simple as adding it as an option under Network-wide > Configure > Al...