Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've got three WAP581's linked with WDS Wireless Bridge to implement three separated LAN segments that interoperate with each other. This works fine with bandwidth set to 20 MHz (5 GHz, 802.11n/ac). One of the WAP581's is also the Access Point for lo...
My RV345 router is running fine, with 13 of the 16 LAN ports active. However, when I logged into its management web page today, the System Summary shows all LAN ports down (red down-pointing arrow). The WAN port shows up, as expected. Other status pa...
Yesterday I ended up checking for new RV340 firmware and discovered the CIsco Security Advisory on the Authenticated Remote Code Execution Vulnerabilities. I downloaded and installed the new firmware, version 1.0.03.21. However, with both previous fi...
Apologies if this has already been answered. I have SAP535G2's provisioned with multiple extensions on each. When returning a missed call, it is important to call back on the same phone number (extension) that the missed call had targeted. Following ...
As mentioned, I'm working with 5 GHz, 802.11n/ac. I didn't mention the channel and upper/lower, but these parameters are also identical for all three WAP581's. My WAP581's just sat there for about five minutes without linking up. I rebooted a couple...
Agreed - my RV345P is again showing all LAN ports down. I would need toreboot every few days to avoid the issue. I've stopped bothering withrebooting all the time. Basically, the LAN port status feature is busted.Cisco is OK with this?
Router firmware version is 1.0.03.21.And while opening the RV345 web page just now to confirm the version, I just noticed that all the LAN ports are indicated DOWN. The original issue returned sometime in the past 36 days since the RV345 was rebooted...
Well, I managed to reboot the router - now all the LAN ports show the correct up/down status. Something to keep in mind to avoid unnecessary excitement in the future . . .
Today I deployed a new RV345P router (for reasons not related to this issue). Before connecting it to the internet I upgraded the firmware to the latest version and during configuration I made sure there were no cracks in the firewall. Later I checke...
