About 5aschulz

5aschulz · 04-10-2007

I have a 2620 being used as a console server. I have an async 32A card in it with two octal cables connected to my deivces. When trying to reverse telnet to any of the lines, all I get is: % Connection refused by remote hostHere is the configuratio...

5aschulz · 06-30-2006

This is both a LAN/WAN issue. I have two routers with redundant DS3 circuits to an external site. The network at the external site is summarized at these routers.If one circuit goes down routing will fail over to the other circuit and everything wo...

5aschulz · 04-10-2007

the flowcontrol statement is on line 1 which is a modem. The lines 33 to 64 are the async lines I'm using for the console connections and I do not have that configured for those lines.

5aschulz · 04-10-2007

Here is the output of show line:DDRTS1001# sh line Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int 0 CTY - - - - - 0 0 0/0 -I 1 TTY 115200/115200- inout - - ...

5aschulz · 07-10-2006

Thanks for everyone's responses, but I'm going to go ahead and open a support case on this issue.

5aschulz · 07-07-2006

I want that summary propagated to the other areas. I don't want all those /24 routes floating around. I just don't want it advertised until all the /24 routes are back in the router's table after a circuit outage.

5aschulz · 07-05-2006

Those /24 routes are not being learned by the switches because there is a summary being sent instead. The 10.20.0.0/16 network is in area 5 not area 0.I will do a debug next time it goes down. It doesn't happen that often.Thanks for your help.

Member Since	‎06-30-2006 06:47 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	9

User Statistics

User Activity

problems reverse telnetting

OSPF advertising of summary routes

Re: problems reverse telnetting

Re: problems reverse telnetting

Re: OSPF advertising of summary routes

Re: OSPF advertising of summary routes

Re: OSPF advertising of summary routes