Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI am running Video streaming over a 1410 Wireless Bridge. All was running fine as I am only pushing about 3mb/s over the link. However in the mornings the link has been failing. I am getting 1Volt over the RSSI and have perfect line of sight. I ...
No I run the 1410 through a power inverter so I use the 240AC device supplied by Cisco. My total power includes the 1A @ 12V lost by the power inverter.I did consider going 48vdc however I also need to power 24vac, 12vdc 7.5vdc at the remote trailer...
You should possibly be using Access Points not Bridges. This problem is looked after by spanning tree protocol in Access Points by having a Primary Access Point that everything goes through with STP turned on. If you have a blind spot you can set u...
Ok improved things somewhat. I have filtered out any unwanted multicasting backloading from other devices. And have let through the two multicasting camera addresses in the required direction. This has releaved the Energy Detect Defers. Retries a...
