Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
as bridges, simultaneously? I can see two wireless links, one is 2.4 the other is 5.8. Can I use one 1200 chasis, with 2 radios in it, to aggregate traffic from each band to the ethernet port as bridges?Just trying to increase bandwidth and save on r...
I need to span 8 miles using the 1410 Bridge with integrated antenna. I configured the bridges in a lab and confirmed that they "talk". Taking them out to the span, the units didn't connect. So, I saved the configurations and placed the bridges in "i...
Hi all,I have an exisiting Pt to Multipoint network of 1410 bridges. Connected to each bridge is a 1200 AP. I want to put the clients on one VLAN and the "equipment" on another VLAN.I think I understand that you have to configure both interfaces on ...
thanks for the reply.What I have done is, pre-configured the bridges in the lab before install (they communicate). One is root and one is non-root. Upon installation (on a span that worked with a lesser pair of radios), the radios don't communicate.W...
if the 1200 has a "a" radio set to root/non-root bridging, will it communicate with a 1410?The current IOS allows bridging in the 1200 series. Is it the same frequency as the 1400 series?
Do you know if the "a" radio in a 1200 would communicate with the "a" radio of a 1410 bridge? Same frequency? Can't seem to find it on the 1200 and 1400 product literature.
