Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I want to forwards Cisco IDS logs to Symantec Security Manager device. But i am not getting procedure for implementing it.Thanks & Regards,Shamsundar.
Hi Experts,I wanted to know the default services running on Cisco switches.Is there any way by which i can identify the services running on cisco switch.Thanks in advance.
Hi Experts,i want to know does ospf precalculates the secondary path in advance. like EIGRP when primary path fails in Eigrp it takes the fessible successor as a next best path for routing.so does this is supported in ospf????????Thanks in Advance Sh...
Dear Experts,I want to perform the syslog analysis of my routers switches and cisco firewalls.I have forwarded the log messages to syslog server.i am interested in knowing which messages comes under warning and information level.If any document is av...
Hello all, I wanted to use SNMP feature of Cisco RPS 675 but i dont know how to connect it and use the SNMP feature. could some one help me. I will be very much thankful towards u.Thanking You.sham
Hi,Thanks for your reply, but my requirement is to harden the switch so i want to stop unwanted services like finger service, tcp-small-servers etc.RegardsShamundar
hello,i have two routers connected by serial interfaces and on both the routers e0 lan is connected. i want to bridge the ip trafic between both routers genrated from lans (s0-s0) and on other interfaces i want to enable routing. so help me out.thank...
hi,As per me,OSPF supports equal cost path load balancing.U can set the cost manually. so if u have more than one paths with equal cost they will load balance .default it supports 4 paths for load balancing and maximum it supports upto 6 paths.load b...
