Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a pix 515 that was running IOS 6.3 and I just upgraded it to the 7.24 IOS. I followed the steps from the Cisco web and during step 2. where you send the .bin file to flash, I get a "host not found" error. I have done everything I can to get it...
Hi,The Security Natzis have asked if i can hide or disable the user from seeing the network configuration page of the phone. I would still need to let the support people have access to it. If anyone has herd of this please let me know.
Hello all,I have a basic setup question. I am a newbe when it comes to this part of CCM configs. I am setting up a single CCM and Unity system that will service 4 remote sites connected by WAN. Each site will have its own PSTN GW configured in CMMy g...
HelloI am using CM 4.1 and a VG-200 with a 2FXO-M1 and a 2FXSI have H323 configured on the 2FXO-M1 so I can use the caller-Id feature.The CM has a route pattern of 9.@ for out bound calls. Under MGCP control, all outbound and inbound calls works ok. ...
I have CM 4.2 I would like to know if there is any way to get call manager to see a MC3810 so it's FXO's and FXS's can be configured for MGCP. The MC3810 is not in the list of gateways that can be configured.
I resolved my issue after reading more post. The proble was actualy the ATA device. I only had port 1 configured and when port 2 would try to do a TFTP pulldown, it would rest the device. after disableing the port 2 on the ata. the problem went away.
It is a straight shot to the GW. They are on the same switch (3524), VLAN and sbubnet. I though about using a data and a voice vlan but there is not enough traffic to cause this.
I am having the same symtom with international dropped calls. After about 2 min the call will drop. It does not do it all the time but it is a problem. I am using a real basic VG-200 GW FXO to a PSTN. The GW is using H323 and a basic VOIP config. Any...
That worked.Adding the CSS, changing the discard digits to "none", and removing the prefix 9 solved it. I added the "prefix 9" as one of my attempts to get it working. Thanks all for you help!
