Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have multiple locations with GRE IPSEC tunnels running on Cisco Routers between the locations. I have two main Hub sites and several remote sites. Most of the remote sites have two different ISPs with 3 tunnels total coming out of the remo...
I have an ASA 5510 that has a static IP with a site-to-site IPSEC tunnel to an ASA 5505 with a static IP and that works great.However, I know need to create another tunnel from the ASA 5510 to a different ASA 5505, but this 5505 has a dynamic IP.I ne...
I have a Cisco 2811 that is connected to our Service Provider over an MPLS network running OSPF. We currently have (2) T1 cirucits and we are load balancing the two. I am going to add a third T1 but was told I need to do MLPPP.First, will this router...
Can I do some sort of dead connection detection on my PIX 515, where I have 2 default routes defined going to different ISPs, but it uses one as the primary and only use the other if the first connection is down?If so, what configuration would I need...
I have a 1720 router with a 4 port Ethernet switch in one of the modules and the router does not recognize it. The LED for the module comes on and states WIC 1 OK, but the router does not recognize it. I upgraded the IOS on it to the latest. Doesn't ...
Rick, thanks. This is pretty much what I figured. If you have done it on a 2621 it should also work on a 2811. I was worried about overhead as I heard this adds a lot.But why do you have fragmentation disabled? Is it not needed?It seems like we have ...
Can you explain what you mean by get all specific prefixes over MPLS as opposed to default? MPLS is very new to me.And can you elaborate more on Null-routing aggregae block?Thanks again for all your time and effort!
The tunnels would actually be established between the two watchguard firewalls at either end. The 1841 routers sit behind them.So, if I understand correctly I can build the tunnels between both fireboxes and have them active as the internal LAN will ...
