Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, we have below architecture for backhaul design, where root and mesh access points are kept at the same height.1) 2 root access points (APs) are connected to the wired network.2) mesh APs are used only for backhaul—they do not serve clients.I wou...
We have planned to use IW9167E for the field deployment in Mesh and root mode. Our plan is to use omni directional antenna 4x4 from radio 1.i would like to understand can we have 2.4 and 5ghz band from same the radio at the same time with one externa...
Hi, we are facing an issue registering the license with Cisco CUCM. Currently, we are at the site and there is no internet. This is first time registration for the CUCM server. Could you please suggest how to activate the license?
Hi, We have a strange requirement from our customer to connect two PABX systems over an analog trunk.Currently, analog phone is connected to PABX A over 1 pair cable. Our customer wanted to connect PABX B in place of the Analog phone to have a one-li...
We have a situation where we might need to place 4 hops between RAPs. Hops are used only for the backbone purpose, not for client traffic. We have very little requirement for bandwidth approx 20 Mbps. cisco model is IW9167E.
Thanks.Our plan is to use only one omni directional antenna for mesh points as LOS is good towards root access points. my question is, do we need two antennas to provide backhaul communication with two access points or one is enough as there is enoug...
Thanks, Saikat, for your response. The presentation was very useful and clarified a lot. I have a few questions for which I could not find answers yet:Can we use Universal Backhaul Access (UWA) in IW9167E, where the same radio can be used for both cl...
Yes, I have gone through the install guide. I wanted to use the same tri-band antenna with 4x4 MIMO capabilities, where radio 1 will be used for 2.4Ghz and radio 2 will be used for 5Ghz band with 2x2 capability, so i can use only one antenna since we...
Thanks for your response. I got the clarification on the Radio side.I have a quick question that We are using a 4x4 MIMO Omnidirectional antenna. So if we want to use the 2.4 and 5 GHz bands, we have to use 2 nos of antennas with 4x4 capabilities. We...
