Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I have asterisk pbx and cisco 1760 router. Router connect to ericsoon pbx with e1. Router is behind Nat. I made one-to-one nat. When i call cisco router from asterisk i take an error. I am sending debug ccsip all output. How can i solve this pro...
Hi, I have Trixbox PBX and Cisco 3725 Router. Both of them are in same lan. My router has E1 interface that is connected to LG-PBX. My LG-PBX agent can call Trixbox agent directly over PRI. But when trixbox user try to call LG-PBX agent i take "SIP/...
Hi, I have Cisco 2811 router with VWIC-2MFT-E1. One port is for PBX and other one is for Telco PRI line. My Telco Number is 8664900 with 100 DID. I dial this number and router answer the call. I want to transfer all incoming call from Telco line to ...
Hi,Nowadays, we have got many complaints from our customers about empty calls. They have different models cisco routers in their networks. They make VoIP on it. Our voip supplier use the cisco bts in their backbone. When I checked the cisco router ca...
Hi, I have Cisco 1760 router with 2 Mbit Leased line internet access. In network there are 10 users. I want to share internet line between 10 users. One user can have 200 Kbit upload/download speed. Is it possible to do that, each user can have dedi...
Hi, I solved problem. Install g729 codec to trixbox and on trunk screen i write disallow=all,allow=g729. With this commands i can call to my pbx extensions. Thank you again. Ufuk Güler
Hi, I have pots dial-peer to accept and transfer incoming calls to LG-PBX PRI line port. I cant write codec g711u command under this pots. Thanks help.dial-peer voice 11 pots destination-pattern 1.. no digit-strip direct-inward-dial port 1/0:15 forw...
Hi Walter, Many thanks for answer. I solved my problem using another PBX PRI card. I connect Telco line to this card. And PBX answering incoming PRI calls. But as soon as possible i try your solution. Thank you...Ufuk Guler.
Hi,I have checked some debug messages which are debug cch323 all. I saw that peer to peer calls like H.323 calls. And linksys accepts only SIP calls. Because of that Cisco's calls unrecognized with Linksys. Then I wrote "session protocol sipv2" comm...
