Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I have a question about default route functionality. Heres my scenario:I have 2 9500 stacks in 2 separate buildings connected via a trunk. In stack 1, I have a vlan defined and its gateway is on this stack and the default route points to ...
Hello,I am currently setting up a new network at my company and have a question about my design. We have 2 buildings side by side with fiber between the buildings. I bought 4 9500's for the core and have set up 2x2 as stackwise stacks for a collaps...
Thanks Rick, I didn't think it would but that's why we ask our colleagues #1 is the option that I have been planning to use. We have a pretty robust wan infrastructure with sd-wan with 2 circuits, 2 fw's all fully meshed for failover so I was jus...
Actually, I want to test default route failover on stack 2 since their production vlan gw's are on stack 1. There is no default route on stack 2 currently. So I want to configure one and use a non-production vlan with its gw on stack 2 to test rout...
Hi Richard,To answer your question, the way we're setup is we have 2 buildings side by side. Each building has its own internet circuit, fw and sd-wan appliance. Currently, the circuit in building 2 (stack 2) is not being utilized because their dat...
Thank you Rick, that's what I was looking for. Yes, the GW for my vlans on stack 2 are on stack 1. I have 1 vlan in each stack that are not used in production that I have routing through ospf and want to test def route failover without interrupting...
