Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
IP accounting on Cisco 7613 is not giving any output. Is there any other command on cisco 7613 to check the traffic flow on a particular interface of 7613 which can show the source and the destination for the traffic flow.
we have around 30 switches and 51 vlans configured in our lan. Recently we have added 1 vlan ( vlan 154 ) ( 3 months back ) and enabled a device on the switchA same was working. Now the device is out of the network.we tried changing the ip adress of ...
I need to limit the bandwidth of Ethernet port of 2950 switch to 1 Mbps. Is there any option in 2950 for rate-limiting or traffic shaping by which the same could be possible.
I are facing problem in DHCP ( Configured on cisco router ). Machines with OS XP are not able to obtain the ip address through DHCP server whereas machines with other OS are able to get the ip address through DHCP. Can anyone help me in this regards ...
Wse have a WS-C3548-XL-EN switch whose cpu utilization reasches 99 % dails between 12:30 hrs to 1:00 hrs. When chcked it shows that address learning process is occupying most of the cpu. Have checked that none of the port on the switch goes down or c...
If static ip given the pc works absolutely fine. There are around 200 pc out of which 140 are getting ip address properly from dhcp. Most pc not getting ip are XP.Event Type: ErrorEvent Source: DhcpEvent Category: NoneEvent ID: 1002Date: 10/28/2006T...
Pls find my dhcp configurationip dhcp pool PKTnetwork 10.2.188.0 255.255.252.0default-router 10.2.188.1netbios-node-type m-nodedns-server 10.2.188.9Eventhough the subnet mask is 255.255.252.0 the client takes the ip address but subnetmask as 255.0.0....
1. Is the router in LAN or wan. 2. If wan how do u connect what is the connectivity . 3. Whether there are 2 links to the site and whether the traffic is getting load balanced betn two links.4. Type of load balancing per-packet ot per destination.
As i understand.Following should be the command on our primar link interface.int < interface number >backup interface < interface number >You just need to add. this command more.back load 80 60This command states that whenever load on primar link is ...
