Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Below is the router and interface configuration of two 3725 routers. The problem is, I'm not able to ping PC connected to each router (PC1 connected to Router_01 and PC2 connected to Router_02, (Router_01 directly connected to Router_02). I'm able ...
Sorry for the double posting of this message... When I did a reload/hard refresh of the page it posted again.Hello Sean.OOPS! I didn't look at my last post, I just looked at yours and I didn't realize that you had posted a correction to what I had po...
Hello Sean.OOPS! I didn't look at my last post, I just looked at yours and I didn't realize that you had posted a correction to what I had posted. I had the network address for all routes on each router's RIP configuration. You're right I did have m...
Hello Sean Conway and others that have sounded in on this problem...I have been digging into this problem all along then I was out of town for a while. I never got the original computers to talk properly across the routers and I gave up on them due ...
Hello Rick, and others.I've made some changes.(Focusing on Router_02, if resolved then I can fix Router_01 too).Here is current configuration and output:FastEthernet0/0=148.33.0.1FastEthernet0/1=148.35.0.2FastEthernet2/0=148.36.0.1PC#1=148.35.254.1 c...
Hello GP.I have done all that... As I have indicated in my post, I can ping the router ports from each PC and I have the gateway configured on each PC to match the respective connected router interfaces. Also The cables are correct. I can also pin...