About matta_ralph

matta_ralph · 08-07-2006

Hi,I am setting up a simple NAT router between a private network (172.16.0.0) and a public network (10.2.0.0).The Nat part works, except that the router is blocking UDP from coming from WAN (10.2.0.0) to LAN (172.16.0.0). Only TCP is allowed to come ...

matta_ralph · 09-26-2006

Hello,It is not working.All I configured on the router is:Interfaces:ip nat insideip nat outsideip nat inside source static 192.168.1.103 10.2.240.1 (outside router interface).With this way nothing is coming in or going out.The only working configura...

matta_ralph · 08-11-2006

Thank youyes please I need clarifications. You say it is a PAT issue. In the command, I tell the router to forward packets from the outside to the inside using the allowed private address range of addresses.Is the PAT caused by the "overload", if so ...

matta_ralph · 08-09-2006

I found out the origin of the problem.It is this command that was blocking UDP:ip nat inside source list 1 interface FastEthernet0/1 overload With:access-list 1 permit 192.168.1.0 0.0.0.255To my surprize removing it caused UDP to pass from WAN to LAN...

matta_ralph · 08-09-2006

Thank you for your reply,If I use this command, I have to do it for each port (8000 to 9000). So I used the following which still did not work:access-list 102 permit udp any range 8000 9000 any range 8000 9000 ip nat inside source list 102 interface ...

Member Since	‎08-07-2006 07:18 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	5

User Statistics

User Activity

Cisco NAT issue

Re: Cisco NAT issue

Re: Cisco NAT issue

Re: Cisco NAT issue

Re: Cisco NAT issue