Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently purchased a 2811 router for use in building out my home lab. There was no CF card, and when I use the console it doesn't boot any software, only shows rommon> prompt. Is there a way I can download software to a USB and boot it up from a ...
I did find the software that everyone said was "the" software to get for this router...the last "golden" version, which was 15.1(4)...something like that. I found it under the 1800 series routers... its old but should still work, I just can't downlo...
Thank you for the response. It would seem I have an even bigger hurdle than that now.... After looking around for the actual software that is supposed to be on the router, I found it on Cisco's site, but I have to buy a service contract just to down...
Wow... just Wow... I bought an old Cisco 2811 router that did not have a flash card... I have been looking all over for the software for it in order to make it useable. I finally find it after painstakingly searching through Cisco's need-a-certifica...
