Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I have an SG500-28P that is behaving oddly. Factory Reset via button on the front took ages to respond, I have been told 10 seconds or above and it should flash all lights and reboot. It does not. Finally got it to reboot and now it goes through t...
Hi everyone, I have inherited an existing 2 host setup and have been troubleshooting the network performance since I arrived. I have noticed that not all the VLANs in use by the VMs have been assigned to the LAG group connecting the ESXi hosts to the...
Cisco has removed all of the files for a lot of discontinued products from the portal and that includes all the SG500 series. Considering the fact that a lot of these switches are still out there and that these Firmware updates were free due to sec...
Hi Gopinath_Pigili,thanks I finally figured out what is happening once I got the console cable connected. As I was saying above Console cable for the SG series is female to female DB9 straight through. 115200 baud 8 N 1 for PuTTY with the Control-H o...
Thanks Gopinath_Pigili.Very useful links, I have ordered a cable to connect to the serial port as the only one we had were the Serial to RJ45 console cables for the routers. Sadly am currently working from home due to an injured knee so won't be able...
