Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Please refer to the usage of the 'names' syntax located at http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_7_2/cmd_ref/no_711.htm#wp1646080
Sounds like your customer is working hard, and not smart. The simple solution would be to add an Access Control Server and point the firewall to it. Setup the groups and assign the users accordingly. If you need to permit/deny based on time, you c...
Ive seen that error message a lot when an engineer overlooks their static statements.since we cannot see your config, take a look at it yourself and see if there is a misconfiguration.
