Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 9400 switch with uplinks using a L2 port channel (with second switch) with multiple NVX receivers behind them, I have immediate leave Enable on both sides of this link. - Is this the right configuration ? or should I disable immediate leave ...
Trying to perform a code upgrade on our WLC but receive this error -At least one AP is upgrading image, download cannot startI don't see any of the AP's in the download state either viewing through the GUI or CLI.Has anyone run into this before ? Any...
Migrated (AIR-CT7510-K9 in HA ) from 7.5.102 to 7.4.121Under new code I am now missing the " WLAN WLAN mapping " tab when editing the FlexConnect GroupsCan someone confirm that this option is not available under the new FlexConnect groups?
Issue has been reported on some 7.4 and 7.6 codes where the controller will prevent rebootingthinking one (some) of the AP's is in downloading state even when there are no AP's that show stuck in this process.To fix this, I had to do a forced reboot ...
