Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to do dynamic DNS rewrites using CBAC? I'm looking to do the same type of inspection done in PIX with the 'dns' tag at the end of a static or nat statement with existing IOS hardware.
on your multipoint tunnel change this line:ip nhrp map multicast 10.254.0.1 toip nhrp map multicast a.b.c.dwhere a.b.c.d is your hub's public ip, this should be done for each spoke.
wr memreloadSometimes devices retain configuration even after issuing no statements, in these cases the device must be reloaded to clear the stale lines.
You can configure multiple groups on an interface, so if you have a secondary ip subnet on the same layer 2 segment you can have an hsrp for each subnet.
