Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
As my question states, we want to block Teamviewer in our network. Our setup is as mentioned below..only one proxy server is allowed access to the Internet, the IP of this proxy is PATed on the firewall.We are looking for an access-list statement to ...
We have recently installed LMS3.0 & configured device detection, all the Cisco LAN switches & routers gets detected except Cisco 4506E distribution switches.Under the device Type they appear as ciscoProducts.875, how can we rectify this??Pls find th...
We have 2 x cisco 6500 switches running as a core switches, recently one of the core failed and the other took over.. but this was not the issue.The issue is we have a single DHCP server which was connected to the core which failed and hence there wa...
We have a 2800 router & a 2960 switch in a remote branch connected via MPLS, these devices are known & reachable in campus manager but I'm unable to view these in Topology view/Cisco view. I can see all the rest of the devices within the campus.Regar...
I have a cisco pix 515e with an image version 7.2, but it dOesn't have a license to support VPN-3DES-AES so I have configured it for VPN-DES but unable establish a remote-access VPN connections.The configuration is as pasted below, kindly review and ...
Thanks a lot!!In this case we will Install two DHCP servers with divided subnets.So based on the understanding the DHCP server directly connected to the respective core may assign the ip address to the client and if one of the core fails the other as...
Thanks for your mail, well.. dividing each subnet in two scopes is certainely a good idea and we may do that as well.One other thing I wanted to know was.. if two ip helper-addresses are configured, in this case whether a client request would be sent...
That makes it the same as ASA Firewall which does support CDP.. in this case can we still do other management tasks on RME, DFM, IPM etc; Is that correct!!Pls confirm..Thanks & Regards,Syed
Thanks a lot for that info...I have one more issue, we have a 2800 router & a 3960 switch in a remote branch connected via MPLS, these devices are known & reachable in campus manager but I'm unable to view these in Topology view/Cisco view.Regards,CM
