About pija

pija · 08-30-2007

Hi,As far as I know there are no support of EoMPLS for the port-channel interface on any of Cisco routers or switches. I was wondering what is the reason that Cisco implemented EoMPLS on SVI but not on the port-channel? Are there any issues with MAC ...

pija · 08-30-2007

I assume that your GRE over IPSec configuration is working thus it's enough to add IRB related lines in global config as well as interface mode. An example of such a configuration attached below. Enjoy!Testing topology:[Host 10.0.0.1]-----[10.0.0.2 (...

pija · 07-26-2007

There are two settings:1. You can set up MTU on an interface and all packets will have increased MTU.2. Use MPLS MTU thus only MPLS packets will have a higher MTU.Anyway in MPLS enabled network you should always increase MTU on switches. I heard abo...

pija · 07-25-2007

MTU on Ethernet interfaces should be increased to 1500 + 4 for each MPLS label. Usually 1512 should be fine.Some web sites might be protected with firewalls which set DF flag and do not allow fragmentation.Try to do an extended ping with sweep size f...

Member Since	‎08-17-2006 12:11 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	4

User Statistics

User Activity

EoMPLS on port-channel

Re: IRB over VPN

Re: after upgraded to MPLS backbone -- urgent !!!!!!!!

Re: after upgraded to MPLS backbone -- urgent !!!!!!!!