Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My router is RV340 bearing Firmware 1.0.03.22. I have a weird problem with the router.I have 2 ISPs providing me internet. Both the ISPs have provided their proprietary router.I have hooked the 2 ISP routers in 2 WAN ports and set them up as DHCP cli...
My router is RV340 bearing Firmware 1.0.03.22. I have a weird problem with the router. I have 2 ISPs providing me internet. Both the ISPs have provided their proprietary router.I have hooked the 2 ISP routers in 2 WAN ports and set them up as DHCP c...
My router is RV340 bearing Firmware 1.0.03.22.I have 2 ISP in WAN1 and WAN2. My requirement is For the "RANGE" of ip address between 192.168.0.1-192.168.0.199 gets routed via WAN2Similarly for the range of ip 192.168.0.200-192.168.0.254 gets routed...
Hi I have RV340 Dual WAN Router and my firmware and I had the IPS switched on in the following mode when the router firmware was at firmware:1.0.03.20 <ips xmlns="http://cisco.com/ns/ciscosb/ips"><enabled>true</enabled><mode>prevention</mode><level>s...
I own a CISCO RV340 Router. This Router was purchased via Amazon India. I am facing a problem in the LINK/ACT LED display on the port of LAN-1 in the router. The LAN-1 port of the RV340 is connected to an unmanaged Switch and in turn the Switch rende...
Thank you very much for this direction.A noob and silly question. I went to create a VLAN but found that the Add icon on VLAN is disabled !!! Why so ? Is my RV340 on a Evaluation mode ? Why would be the Add VLAN disabled for my case ? Nevertheless, I...
Dear SirThe routing entries did not work. even the ifconfig when put in Asus router broke the WAN access.I telnet-ed into the Asus router and made all the changes. This is getting as a real challenge for me.
@nagrajk1969 wrote:Hi So, yes an additional step would be to simply disable NAT on the Router2.- then the src address of each of the 192.168.75.x hosts/server will not change....- and there will be NAT done anyways on RV34x WAN interfaces, before be...
Thanks for your prompt reply. Helpful as always. Please see my answers below in green text.@nagrajk1969 wrote:Hi >>>I know there is a policy based routing under multi WAN but it would not recognize the network 192.168.75.0 since the LAN is >>>192.168...
Hi @nagrajk1969 Your clues gave a lot of help for me. I connected a RaspberryPi with Debian Linux installed to check the problem instead of a Windows PC. And it seems I have got the issue. I had configured the WAN 1 DNS as 1.1.1.1/1.0.0.1. The name ...
