Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a 1200 AP (ap1220b a k9) with a AIR-ANT 5959 connected. The radio interface shows up. SSID is set to broadcast however we are seeing no signal by multiple laptops. We have tried unplugging the antenna and placing the PC next to the AP with no...
We have multiple 1200 throughout our property, but we have one that is causing problems. No radio.interface is up, ssid is being broadcasted. Have a AIR-ANT5959 antenna attached. However, netstubler not picking up the AP.
We have a 1605 that we are trying the following: Our ISP is providing a DSL circuit with a single public IP address 69.xx.xx.130. We would like to assign that address to ethernet1 and then configure ethernet0 with an internal ip address 10.0.0.1. The...
We have a 1605 that we are trying the following:Our ISP is providing a DSL circuit with a single public IP address 69.xx.xx.130.We would like to assign that address to ethernet1 and then configure ethernet0 with an internal ip address 10.0.0.1. The g...
It has a B radio which was working two days ago. We are using IOS via web page. We have also completed a factory hard reset of the device with still no success.
so now that you have shined some light on the need to be running nat. Is the process different in order to redirect tcp ports to the private side. Ie run web server on private ip side of router, accessed thru the public ip address?
I was able to successfully perform all these commands. (with the change noted for the ip nat command)However, clients on private side can't either ping the ISP gateway or tracert to a public ip. In addition, from the router we can ping the ISP gatewa...
