Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am trying to implment l2vpn over Cisco Modeling Lab through DevNet Sandbox using CSR1000v routers but it has limited funtionality when I try to implement VPLS and EVPN L2. Can someone suggest if it is even possible to implement these using de...
I have a setup whereCE1 connected to PE1CE3 connected to PE3PE1 and PE3 route reflector clients to RR.I have set the local preference for all CE1 routes to 200 on PE1.Later I have set the community for CE1 routes to 65000:101 I can confirm that PE3 ...
I have two PEs connected with one CE each, both of the PEs are connecting to one RR1. RR is recieving the routes from PEs and it is sending them as well but for some reason PEs are not installing the routes.RR1router bgp 65000bgp cluster-id 100bgp lo...
PE1 has two vrfs configured CE1A and CE2A.Both CE1A (155.1.111.11/24) and CE2A (155.1.112.12/24) are advertising their loopback addresses.I am trying to leak the loopback of CE2A (150.1.112.12/32) into CE1A without using the import route-target.I h...
I am using the following topology. I cannot ping from CE1 to CE2. Any help would be appreciated. 150.1.22.22/32 is CE2 loopback and 150.1.111.111/32 is CE1 loopback.
Hi @Harold Ritter ,I realized my mistake, i was mistaken in thinking that VPNv4 can be used without having to import the VRFs in the PEs but now I read more about it and realized that it solved the problem of having mesh between all PEs but importing...
@MHM Cisco World Yes I tried that option but I was thinking if it is possible to selectively advertise it. So that is the only way possible importing all and then filtering it out? Would you say that it is the best practice adoptive in the production...
