Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey Guys,Is there a way for Cisco client based users to use static addresses instead of receivinga a dhcp address? This will be setup on a Cisco 2801 router. We usually just do dhcp but this customer is requesting static address for each user.Thank...
Hello,We have a 7206 and have several channelized DS3 cards we use for T1's. We currently have some of the T1's in a vrf working great. My question is if we can add a routemap to the same interfaces that have the ip vrf forwarding command on it? I...
Hey Guys,We currently have several remote sites that connect back to our core (7206vxr) via p2p t1's. One Site connects back to us via MetroE. All Sites are setup under 1 vrf. The sites that have t1's can ping each other with no problem even bumpi...
Guys I'm sure this is a goofy question but I can't seem to find the answer. I am wanting to know where a can find the difference between the different feature sets?Example: Entrprise plus, ip, ip plus, remote access server, etc etcIs there a feature...
Hey guys, On the 4500m router it has the old db25 female connector for the console port. Can you guys tell me if this cable will work, it appears to be a db25male to db9 female cable http://www.bestbuy.com/site/olspage.jsp?skuId=7002986&type=produc...
Hello Martin,Yes I am trying to route traffic based on an ACL. I trying to have it route the intersting traffic out of the VRF and into the global routing table. I guess tonight I will try and apply the route map on the serial int that has the ip vr...
Ok I really start losing packets around 275. This was pinging from the Core. 275 seems awfully low almost makes me thing it's something else causing this than MTU.core03-atl#$1CAN-Canoate ip 192.168.0.254 size 250 df-bit repeat 10Type escape sequenc...
Ok I tried this 3 times and upped the DG size by 100 each time. At 300 I started getting packet loss. The thing I don't understand is when setting the "Set DF bit in IP header" to yes I don't notice any differnce than when it's set to No. TX-OPT-R...
