Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI,I have errors in my c2821 gateway that I do not understand. Can somebody please explain this errors to me. I have search around but have not found any answer.200722: Nov 26 13:06:43.961: ISDN Se0/0/1:15 SERROR: process_pri_simple: NO name in GTD20...
HI,I have a c2821 with two VWIC-2MFT-T1/E1 and one PVDM2-64, and want to do DSP resource sharing. I have tried to do by configure a dspfarm but without success. In the docummentation I find regarding this, they talked about NM-HDV2 modules not the on...
HI,In an H323 enviroment you configure 2 dial peers, (one voip and one pots)with the same destination-pattern but different preference to have the gateway to do a path selection if a WAN failure arise.How can I have the same functionality in a MGCP e...
I have a problem regarding translation rules.I need to translate 18 different callingextensions into fully number. The problem is that the "voice translation-rule" only could contain 15 different rules. How can I solve this?
HI,This is a part of my debug output. It did not helped me to understund the *ERROR* and SERROR messages. Q931d: L3_state_change: callref 0xA426 old RELEASE_REQUEST, new NULL_STATE471126: Dec 4 14:22:16.388: ISDN Se0/0/0:15 Q931d: CC_CHAN_GetUserpr...
HI Tom,The problem that I have is that the incoming call don?t go via CCM. The call goes from the PBX in one site 1 via the WAN to another PBX in site 2. So I think I need to configure the rules in the Gateway. I tryed to put "rule 0 9[3-7].. 4631" u...
HI,Do you mean I have to do this in the CCM? Is it not possible to do this under the command,translation-rule 1Rule 0 xxxx "translates" to yyyyin my 2821-gateway?Regards Per
