About alexandre.roi1

alexandre.roi1 · 11-27-2020

HiI use SG500 in stack mode with agregation for host servers between two nodes switches. Working fine. Do you know if this topology of LAG is supported on Catalyst 1000 cluster ?Thanks

alexandre.roi1 · 10-26-2020

On Monitor tab, wee cannot to see Ip addresses of clients. Only 0.0.0.0 appears. Any idea ? Al

alexandre.roi1 · 11-30-2020

Actually We use this configuration on SG500 stack and works very good. We just want to know of this setup is supported on Catalyst 1000.

alexandre.roi1 · 11-27-2020

Hi,I don’t have any config. I just want to know if Catalyst 1000 in stack mode support full mesh LAG like SG500 or SG350x stack. Thanks

alexandre.roi1 · 11-26-2020

Hi,I don't have any issue with DHCP. All devices get IP address but cannot be seen on WAP.

Member Since	‎10-26-2020 08:11 AM
Date Last Visited	‎12-01-2020 07:27 AM
Posts	5
Total Helpful Votes Received	5

User Statistics

User Activity

Catalyst 1000 simple ip management mode LAG with two nodes.

WAP581 firmware 1.0.3.1, Client ip addresses stay 0.0.0.0

Re: Catalyst 1000 simple ip management mode LAG with two nodes.

Re: Catalyst 1000 simple ip management mode LAG with two nodes.

Re: WAP581 firmware 1.0.3.1, Client ip addresses stay 0.0.0.0