About pafcio84

pafcio84 · 06-13-2024

Thanks it was missed on my setup.

pafcio84 · 11-21-2023

Thanks

pafcio84 · 10-08-2023

Yes this is right. But to do this you have to remove portchannel 50 and make for instance portchannel 40 and reasign to eth2/2 and eth 2/1

pafcio84 · 10-08-2023

Hi,You have to crate new port-channel and then add settings again for phisical interfaces: channel group X mode active. When you see only "channel group 10" than you have status NONE. You just have to Recrate port channel.

Member Since	‎10-28-2020 12:07 PM
Date Last Visited	‎07-01-2024 01:07 AM
Posts	4

User Statistics

User Activity

Re: Not able to SSH C9800-L, getting permission denied

Re: Renew HydrantID SSL ICA G2 Cisco ISE

Re: should be......channel-group

Re: Nexus 5000 - Lacp