Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,Currently at corporate location, we have a router with a ATM A1-T3 module. I am in the process of migrating our circuit to AT&T MPLS and basically the new circuit from AT&T will be a T3 PPP circuit. The question to you guys is is the curr...
Hello Guys,We are currently migrating our circuit from Frame-Relay to MPLS. Our corporate will be on a t3 connection acting as a hub to all the branch office. The PTE from at&T that I've worked with sent me the information below. I'm not quite sur...
Hello Guys,I'm new to setting MPLS Technology and not really sure on where to start. Do you guys have any good recommendation on documentation or article on setting up MPLS. Maybe a sample configuration.Thanks,
Hi guys,I'm pulling my hair out. I think it something simple but I cant figure out why my access-list is not working.Here's the test access-liststatic (inside,outside) x.x.x.x 172.16.124.15 netmask 255.255.255.255access-list inbound_outbound extende...
hello all,on our network, we have two gateways to the internet, one a checkpoint firewall and the other is a cisco asa appliance. All the devices default gateway is a cisco 3500 series which handles all the routing. Basically, I want to configure s...
Thanks again Rick, you are giving me a lot of valuable information. I got another newbie question for you. when I do a traceroute from the router that has the t1 to a branch office, it doesn't travel out on the serial connection, instead it goes t...
Thanks Rick,I would hate to see the t1 circuit not being used but your point do make a lot of sense. for redundancy to work. Do I need to setup both circuit on one router? Or it can be on different router?
