I'm working with a Cisco 1700 Router. I need to establish some static port mappings. I am able to telnet into the router, can enter enable mode, and then conf mode. My question is: How do I add a static port mapping. From the research I've done, ...
I'm running CIPC under Windows 7. We have the CDP service disabled, so that's not a problem. The problem I'm facing is I'm not able to configure the headset for mic and speaker (default device is the only option), but I am able to change the setting ...
It was indeed accepting the commands into the runnning config. I entered the translation, wrote the changes to memory, and I can now access the 10.0.0.8 box remotely. Thank you all for your help, I have learned a great deal from your posts!
Edison - I followed your last suggestion and didn't get the error. But, I don't think the command is being added to the configuration. Dhaval - I agree with you there, so I'm going to use port 80. But, do I also need to add an access list entry so...
Well, some good news. In the config file there is the following static mappings:ip nat inside source static 10.0.0.1 206.57.201.219ip nat inside source static 10.0.0.2 206.57.201.220ip nat inside source static 10.0.0.3 206.57.201.218When I remotely ...
Here is what I get when I enter the command above:User Access VerificationUsername: adminPassword:WRPM_1720>enablePassword:WRPM_1720#terminal monitorWRPM_1720#$ip nat inside source static tcp 10.0.0.8 80 203.52.204.226 2000 extendable ^% In...
