Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm working on a MAN project. The client has 3560s at the remote location and 6500s at the Hubs. The Fiber runs in a ring from each individual location back to one of the hub sites. So, the 3560 may have an LX GBIC in one port and a ZX GBIC in the...
I currently have (50) 1020 access points installed with (1) controller on my college campus. I am adding an additional (5) access points the 1140s and (2) controllers for n+1 redundancy.The issue / questions I'm faced with.I currently have a campus ...
4402 controller with 4.0.602 code, MS XP Client, 802.1x authentication, device and user authentication:The controller is configured with (2) SSIDs: Secure, Public.There are (3) VLANs I want to place the devices in after user authentication (obviousl...
I have a client with a PIX running 6.3 code.They need to establish an IPSec Tunnel to one of their clients that has a Checkpoint firewall.Both organizations are using 10.1.0.0 /16 and would like to nat the home office to 10.180.0.0 /16 and the remote...
Check to make sure your controller interface is connected to a trunk on your switch which permits all the dynamic vlans and your management interfaces.Also, check to make sure your access point is connected to an access port assigned to the managemen...
The client addresses are 10.1.0.0/16 at both sites.Only one client work station at the main office is going to be accessed from the remote location. The ip address of that device is 10.1.1.103/32 which should be natted to 10.180.1.103/32.Traffic com...
