I know I can use software advisor to locate an IOS for my routers that has SSH included, but is there a rule of thumb for IOS that includes SSH by default (i.e. IP PLUS, IP SECURITY, etc).TIA
I been attempting to use boot system flash to test a IOS upgrade. However, the router bootstrap only skips that command in the startup config. Am I not using the boot system flash command properly. Here's the bootstrap message.%SYS-6-READ_BOOTFILE_SK...
Is it possible to set a T1 interface threshold or T1 controller threshold to shutdown the interface when threshold has been exceeded?I've got a flaky T1 that regularly takes major hits, but apparently enough data gets through to keep the T1 up. When ...
Is there a delay timer available for the IP HELPER-ADDRESS function? I am getting more DHCP leases completed through my relay agent than my local DHCP server. The DHCP server appears to be practically 0% utilization 24/7 so I can't image the relay ag...
Is there a tool where I can choose IOS releases by the type of hardware that is supported? I am aware of the IOS Upgrade Planner and I have used it, but the tool does not identify if the IOS will support the specific modules installed in the router (...
I implemented the same technology for T1x2. Except I didn't use virtual-template. I basically created a multilink interface and set encap on two serial int to PPP and put them into a multilink group. The only trouble I've ever seen is that my NMS doe...
Are you using a Windows 2003 DNS server? If so there is a known issue with DNS packet size and Windows 2003. To resolve you'll have to increase dns fixup on your pix to a larger packet size. Increasing the size of course requires 6.3 or greater Pix I...
I have two subnets/sites that are connected by a T1. In both sites are DHCP servers (w2k server). Each DHCP server has a portion of the other site's DHCP IP addr pool for failover purposes. I am finding that a large portion of the opposing sites IP a...
This may not apply, but are you connecting the pix to a switch on either side? If so, you could have a duplex mismatch or speed mismatch and the pix or switch port is disabling temporarily. I have two 501s in use and they are quite stable. I made sur...