Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Community, I want to implement a Flex Connect AP with a local 802.1X Auth. on a Windows NPS. My setup is:Catalyst 9800-CLAP Join Profile with Dot1x Credetials Cisco AP (Flex Mode) connected to a Aruba Switch with 802.1X Port Auth via PEAP against ...
Hello community,I've short question, because i can't find a solution for my problem:I want to manage to wlan controllers Cisco 3504 on location 1 and Cisco Catalyst 9800-CL on location 2. Is there a posibility / a tool to managed them centralized (cr...
Hello, We're running a Catalyst 9800-CL with older Aironet 1850 APs and the new Catalyst AP9115. After we try to disabke the older 1850's some older Clients (older notebooks with same old driver gen ~5 years) are not able to see the SSID's broadcast...
Time for updates:I've (possibly) solved the cert issue. By exporting a pfx-file from the NPS and upload it via Configuration > WebAuth > Certificates. Now the cert is set as trustpoint. Then configure LSC Provision via the Configuration > Wireless > ...
Hi Scott, Thank you for your tip. I check this guideline and i did everything as it is given there. But, the problem is still there Edit: I also wonder why the service hostapd is printing out the logs. In my opinion the wpa_supplicant is in duty for...