About nso20

nso20 · 02-16-2021

Hello, I know there is Cross compatibility between NSO version and NED version. But how to know Cross compatibility between Device firmware version and NED version ?e.g.: IOS version 6.x --> NED version 3.xJunos version 20.x --> NED version 7.x ......

nso20 · 01-26-2021

Hello,I succeed to build netconf ned using fetch-module-list, which will fetch all yang models existing on the device. But I need to manually put the yang models (specific yang models I need) on NSO and NOT fetch them from the device. A document says...

nso20 · 01-25-2021

Hello,I succeed to build NETCONF NED via netconf-ned-builder, how to build CLI NED ?

nso20 · 12-07-2020

Hello,I am trying to build NETCONF NED from below yang files, and build succeed but when trying to sync-from device, it gives the error below:admin@ncs# show netconf-ned-builder project myned 1.0 module statusNAME REVISION STATUS---------------------...

nso20 · 12-06-2020

Hello,I built a netconf NED with the yang files:admin@ncs# show netconf-ned-builder project mycisco_ned 1.0 module statusNAME REVISION STATUS-------------------------------------------------------------------Cisco-IOS-XE-features 2019-10-01 selected,...

nso20 · 02-16-2021

Hello,I think this request needs python maapi intervention, you need to parse all the interfaces and check if any of them have ip address the same as the service is trying to configure. Then, in python, you can make your decision either fail and exit...

nso20 · 01-25-2021

@KJ Rossavik ok, thanks a lot.

nso20 · 01-10-2021

Hello @rogaglia Please find below:admin@ncs# show running-config devices device myjuniperdevices device myjuniperaddress 1.1.1.1port 830ssh host-key ssh-dsskey-data ***!ssh host-key ssh-rsakey-data ***!ssh host-key ssh-ed25519key-data AAAAC3NzaC1lZDI...

nso20 · 01-06-2021

Hello@rogaglia yes, I already compiled it via make command. I still get the same error although the ned traces are ok as below, any advise (may be I should select different yang models) ? admin@ncs# show ncs-state loaded-data-models mount myned-nc-1....

nso20 · 12-09-2020

@hniska I tried below but still same error:admin@ncs# show netconf-ned-builder project myned 1.0 module statusNAME REVISION STATUS--------------------------------------------------------junos-common-types 2018-01-01 selected,downloadedjunos-conf-inte...

Member Since	‎06-05-2015 05:25 AM
Date Last Visited	‎02-17-2021 12:04 AM
Posts	47

User Statistics

User Activity

Cross compatibility between Device firmware version and NED version

NETCONF NED manual copy of yang models in cache folder

How to build CLI NED ?

Juniper does not advertise any known YANG modules

Building Netconf NED from only some yang files

Re: How to make sure IP is unique in a simple service to configure IP

Re: How to build CLI NED ?

Re: Juniper does not advertise any known YANG modules

Re: Juniper does not advertise any known YANG modules

Re: Juniper does not advertise any known YANG modules