Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,I will indulge in a little spot of cross posting, since I just now figured out, that my original post might be better placed here.I will recap the issue as follows: I have a RV260P as a router/firewall running two PoE devices (DECT base and ...
Dear all,I have recently decided to upgrade my home network infrastructure and chose CISCO gear to do so. My setup is as follows:------------------- ------------------- -------------------------
|AVM FritzBox 7490|------------>...
Thank you, that did the trick.On my Synology RS819 I had to enable multiple gateways, a setting burried under some advanced settings button. I now can successfully ping the server from my pc!
After fiddeling with the configuration (updated to the latest firmware, couple of resets) and watching the official Cisco TechTalks I am still no further.I have moved my PC to VLAN 10 (192.168.10.20) and I have access to the internet through the rout...
Thank you for your replay, the netmask of the #2 interface is /24.The #1 interface still resides on 192.168.0.6 on the other side of the RV260P (I can access that without any problem on my PC) because I am slowly transitioning the network and want to...
Thank you for your reply,I have now changed the default gateway of the PC to 192.168.1.134 and tracert now goes to the switch ==> good. If by "IP routing enabled" you mean "IPv4 routing enable" on the IPv4 Interface-page, then yes, that is already en...
