Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
****In my setup Switches (N9K) are connected to CSP & it is continuously rebooting.******
Switch INFO:
SoftwareBIOS: version 05.42NXOS: version 9.3(6)BIOS compile time: 06/14/2020NXOS image file is: bootflash:///nxos.9.3.6.binNXOS compile time: 11/...
Hi I am adding devices in DOCKER NETSIM where i observed each added devices (VNF) gets same port no as 8045.But in netsim device tree it showing as diffrent port no as 10034.ncs-netsim listname=ASHBURN-SAE_TENANT1-Dual-Cloud-CSR-EPGW-Dual_Cloud_CSR n...
sw-usnv-core-n9k-02# sh system reset-reason ----- reset reason for module 1 (from Supervisor in slot 1) ---1) At 534386 usecs after Wed Apr 14 07:23:36 2021Reason: Module PowerCycledService: HW check by card-clientVersion: 2) At 604155 usecs after We...
Before sync from please check the device is present on netsim or not, the device should be alive and started in ncsto check same use this command >> ncs-netsim is-alive
if it is not present there, follow below steps to add same and sync it
1.crea...
