Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are running a couple of virtual FTDs in Azure and noticed when we have a port group with several tcp/udp ports listed and added ICMP-Any, pings were not being allowed through. But once we removed the ICMP-Any from the port group and added as a sep...
I have a couple of Meraki C210 switches in an isolated environment and understand that the Meraki switches need communications to the cloud. Can I plug the Mgmt interface on the backside of the switch to the local LAN to allow it to communicate to Me...
We recently opted to go with the Cisco Cloud FMC instead of On-Prem FMC. My question is, has the reporting feature been removed from the Cloud FMC? If so, what has replaced it? Below is screenshot of the reporting section from an On-Prem FMC.Thx in A...
I currently have a few Production FTDv deployed in Azure and looking to resize them. I do see the option where I can resize when the FTD is off. My question is can I resize the existing FTD or do I have to build new virtual FTDs with the new size? I ...
I'm currently following the guide listed down below in order to deploy some FTDs in Azure which I've been able to (still in early stages). However, looking at the guide and referencing other materials online, I always see the Diagnostic0/0 interface ...
Thx for the feedback. The only concern I have with creating a specific vlan for mgmt is this switch is the edge that sits between our firewall and ISP router. Either I would have to give it a public IP address that's within the same address space as ...
I'm using this layout for setting up and configuring Cisco FTDs in Azure and understand what needs to be done. I do have one question in regards to configuring the UDRs for the external/outside subnet as well as the internal/inside subnet. My plan is...
