Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,I have a setup where a PIX501 works as a VPN-client up against my central VPN3000 concentrator (LAN-2-LAN mode with NAT-T).The pix's outside interface is behind an ISP-managed firewall at the remote end, and it obtains it IP-address via DHCP...
Are you running native IOS or hybrid (CatOS/IOS)Also, are you routing on your 6513? (MSFC)Anyway, you need to enable CGMP on the switch.If you do route on the Cat, you also need to enable multicast-routing globally, and a multicast-routing protocol (...
I got that setup to work by following the instructions on this link:http://www.cisco.com/warp/public/cc/pd/witc/ao1200ap/prodlit/wrsec_an.htmThe above link is a briliant cook book for wireless security.I guess your problem could be that the default M...
