Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have created a site to site vpn tunnel between our main office and one of our partner office. On our end the device is Cisco 2811 router.At partner's end there is a Cisco router as well. The problem is that the tunnel can only be created when the...
Dear Support,I have a cisco 2900 series router with the module "SM-ES3-16-P" installed.Now the router is showing two additional internal interfaces gi 1/0(routed port) and gi1/1(layer 2 port) where as the module also shows two additional internal ...
Hello!I want to protect my multihomed Server using ASA 5510.The server is acting like a buffer betwen two networks;buffering data from one network and pushing it to the other.The traffic from both server interfaces should route through a respective f...
//Tunnel status when i ping 192.168.10.30 from 192.168.2.100Router#show crypto ipsec sa PFS (Y/N): Y, DH group: group2 PFS (Y/N): Y, DH group: group2interface: GigabitEthernet0/1 Crypto map tag: APLHBL, local addr 20.21.22.23 protected ...
Thanks for the suggestions however the status is the same. /phase 1 tunnel statusRouter#show crypto isakmp saIPv4 Crypto ISAKMP SAdst src state conn-id status20.21.22.23 1.2.3.4 QM_IDLE 1019 ACTIVE //Show ...
Hi,I do not have nat enabled on my router since the internal server "192.168.2.100" doesn't require to access the internet."show crypto isakmp sa" results remain empty unless i initiate the tunnel in which case following output is received. "Router#s...
"ip source-route" was from an earlier configuration and no i don't have dynamic nat enabled on the router.Do i need to have any other configuration to allow VPN session from "192.168.10.30" to "192.168.2.100"?Thanks
