Hi,Trying to set up an Operation form:Monitor> Performance Settings> IPSLA> Operations:When configuring the IPSLA UDP Jitter Operation, you must specify a target port number. But you can not specify a source port number used by this Operation.To be s...

I'm trying to add a C1841 router runnning (C1841-IPBASEK9-M), Version 12.4(24)T4 as a IP SLA Enabled device from LMS 4.0 Monitor> Performance Settings> IPSLA> DevicesThe command "IP SLA responder" exist in the C1841 IOS version but the device is not ...

I have reached the limit in "User Define Groups". How and where can I change the default setting for User Defined Groups. The default value is 100.

I'm configuring Agentless Authentication based om MAC addresses sendt from the access switch using MAB (MAC Authent. Bypass). I got it up and running, but with just one MAC address configured in the Authentication rule. When I try to configure more t...

Will VRF-lite be supported on the cat3750G-12S-E switch.If yes...how many vfr's will it support and which IOS version.