Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi.I have been reading the guide "Configuring ports and interfaces in 4400" and I have one dude about how can I support more than 48 AP in 4400.The guide says "The access point then joins the controller using that isolated VLAN with Layer 2 LWAPP. Al...
Ummm It's seem to be aaa authorization command CONSOLE that point to Radius or TACACS server. Do you have correct persmissions to be on "enable mode"?Good luck
I have a 6500 with VSS FWSM and ACE.I suggest to not to use RHI.I find 2 errors on plattaform:- Wrong RHI in failover between FWSM (I use 4.1).- Wrong RHI in VSS and ACE (inject wrong next-hop on VSS).Then I suggest to go with static route. KISS.Bye.
Umm It sound like RTP stream can't reach Polycom (audio stream).Do you are using Gatekeaper?If Polycom start call, does it work??I think that it work for 20 seconds can be that match any session exist.
Hi. Thanks for the answer. Sorry but I still don't understand the cuestiong. The LWAPP traffic ingress in the controller with the Vlan 992 and egress the controller in the same Vlan (I suppose). But the user's traffic ingress in the access vlan and e...
Hi,I think that the document with the title "Catalyst 6000 and 6500 Series Architecture" can help you... Perhaps it's out-of-date(expecially the supervisor 720 not incluided), but it's a briefly explanation.This document can be found it in Google. I...