Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a single FTP server behind and ASA 7.2 firewall.The FTP server is our primary FTP server and listens on the standard control port 21 using passive FTP.We need to use the same server to run a separate instances of FTP but on control port 2121.T...
I am trying to accomplish a private VLAN solution on a 3750 switch, but I am running into a bit of trouble. I am using the 3750 as a layer 2 switch only. I have a trunk connection from g1/0/1 to a VMWare server that is passing me VLANs 800-809. I ...
Hello Everyone,I am having a problem with throughput on an LRE 2950. The profiles are set to 4-1 which should be usuable for any SNR above 15. The SNR on all the links is running at about 32-35. There are many RS errors. The cabling is new CAT 3 ...
I have a Dell D600 laptop running the Cisco VPN Client 4.0.2.The problem our team is experiencing is once we connect to a network, the Dell latop will freeze for approx 1-2 minutes. There will be no response from the laptop. If you open an applicat...
Can anyone find a compatibility matrix that shows the recommended CatOS/IOS images to install on a 6509 in hybrid?For instance, I install 7.6.1 as the CatOS, what IOS can I run on the MSFC1 and know that it has been tested to be compatibilty with 7.6...
I have decided to go with the second NIC in the server and simply use a 1 to 1 NAT with an individual internal and external IP for both NICs.I wish I had the environment to test this. I think both will fail on the data side and both will work on the ...
Here is the keepalive information I was looking for. Read carefully that DPD only works if the router needs to send traffic. If it is idle it will not send a DPD. Therefore, to keep the session up, the keepalive will need to be forced at peroidic i...
When I have had problems with DMVPN it has always been a reachability problem to the remote peer generally because I have to go through an Internet service provider NAT to a private IP or a firewall in between hub and spoke that you dont know about.I...
You are correct on both questions.All port 23 traffic will be "marked" DE.A DE list has nothing to do with dropping traffic, it just marks or doesnt mark traffic.
Without getting to wordy, the router-id in ospf is used as a tie breaker to a route if all other metrics are the same between 2 routers to a destination.It is always best to set the router-id with the command:router osfp 100router-id 192.168.1.1If th...
