Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all, I have an ISR4331 that was running 16.9.x software and that had the Suite AdvUCSuiteK9 activated previously. I do not use or need that feature. As part of the upgrade to 16.12 or higher, Smart Licensing is mandatory. When I upgrade and reg...
Hello,I'm trying to setup monitoring of IOS-XE devices using Streaming Telemetry to replace SNMP. I'm able to get some data through my Telegraf-Prometheus-Grafana setup, but it looks like I'm not getting all the entries in the YANG tree. My devices a...
Hello, We have certain teams that have very limited ISE GUI permissions for both Menu and Data. The purpose is to give them as simple an interface as possible but enable them to add/edit/delete endpoints that will have access to their specific networ...
Hello,I am trying to implement some Posture checks for MacOS X when users connect to VPN. I was able to get some simple conditions to work, such as verifying that the Anti-Malware software is installed and up-to-date, but I need to do one more test: ...
Hello,Is there a report in Cisco Prime Infrastructure 1.4 showing the unused switch ports? There used to be one in Cisco Prime LMS (Reclaim Unused Up/Down Ports Report).Thank you,Luke
Hello,Did anybody find a solution to this? I took a new 9130AXI AP out of the box, and tried to join it to a new 9800-CL running 17.6.3. After troubleshooting for several hours, I tried to join it to another 9800-CL running 17.3.5a. I'm not sure how ...
Hello,I also tried to do the packet capture on a 9800 WLC running 17.3.5a, and got the same error message "Access point is not capable of packet capture". The client MAC address I specified was associated with a 3802 AP, which, based on the link ment...
Thanks Leo. I tried the "factory-reset all" command and it worked perfectly. The only thing to be careful with is that after you've booted back into an IOS image, change the config register, as it gets value 0x8000 which tells it to ignore all conten...
I saw that command, but it says "Move to permanent mode". That doesn't sound like what I want to do, I want to remove this feature, not make it permanent. Are you sure about this?
